Omni Light Installation Guide: Step-by-Step Instructions

The Omni Light is an adaptable 3 in 1 LED lighting unit that can be used as an indicator, brake, and tail light. It's sold individually, and each box contains an Omni Light, an Allen Key tool for the top cap, and an instruction manual with a QR code that directs to the installation video.

Installation Tools and Components

Omni Light Unit
Allen Key
Fastening nut and washer
Wiring splitter (optional for stop and tail light function, not included)

1. Preparing for Installation

Identify the installation location for the Omni Light. If integrating with a headlight, remove the fixing nut and washer provided as the Omni Light's body thread will serve as the fastening point. Like all of our other indicators, the Omni Light can be used as a headlight fixing bolt.

2. Attaching the Light

Position the Omni Light at the desired location and thread the cable through the mounting point. If using the light as a headlight fixing bolt, directly fasten the light to the housing of the LED headlight and do not use the M8 nut and washer.

3. Securing the Light

Use the Allen Key cap on the top of the Omni Light for fastening. If the location is tight, use the small tool hole on the side with a pin punch or small drill bit to secure the light. Max torque for the Allen key head is 1-2nM, over tightening will cause damage to the lense.

Avoid over-tightening the top cap to prevent lens damage. A gentle tightening is sufficient to secure the unit.

4. Wiring the Light

Connect the wiring according to the function of the light:

Yellow wire for the indicator
Black wire for the ground
Red wire for the stop and/or tail light (use the optional splitter if necessary)

5. Crimping the Wires

When crimping the small wires, take care not to strip them excessively, but expose enough to fold the stripped wire end over to provide more bulk for secure crimping. Solder the wires or use bullet or spade terminals to ensure a tight and secure connection.

Final Steps

Once the Omni Light is installed and wired, test the light to ensure all functions are working correctly. Adjustments can be made to the positioning if necessary. We have designed the Omni light with the understanding that Bike Builders need a indicator that gives you options with how it is installed, and we are excited to see what you will do with them!

For further guidance, refer to the instruction card included with your Omni Light or view the installation video by scanning the QR code provided.

Purpose Built Moto

Omni Lights 3 in 1 LED Indicators / Tail Lights Black

$70.00

~~$70.00~~ $70.00

Sale Sold out

Shipping calculated at checkout.

Product variants

Quantity

Size and Fitment

Dimensions:
Diameter: 16mm
Body length : 16mm
Total Thread Length: 16mm

Wiring:
Red to brake or splitter
Yellow to turn signal
Black to ground

Installation:
M8 x 1.25 threaded mounting hardware
The mounting options have been improved with a 3 piece design, allowing the user to disassemble and modify the offset spacer easily.

Installation with the optional splitter is required for use with Tail and brake function.

Wiring information can be found in the wiring diagram - product card

Technical Info

Certification
ECE approval / ADR compliant: E13 10R - 06 16729
DOT Compliance: Approved

Specification
Voltage: 12Vdc (not suitable for 6V)
Weatherproof: IP65
Lighting output: High intensity LED Red and Amber
Materials: Billet Aluminium housing with stainless steel mounting hardware
Surface treatment: Hard anodised surface

** Warning: Colour anodising may be damaged by certain chemicals or abrasion and can be prone to sun-fade if exposed to these conditions.

Returns + Warranty

All products are backed by our 12 month manufacturers warranty and are sold with a 30 day return policy

For more information on Purpose Built Moto's warranties and returns policy click here

View full details